If these or any label becomes damaged or illegible, install a new label in its place. Recovery tank drain hose M.
Solution tank drain hose B. Recovery tank cover N. Squeegee hose C. Recovery tank O. Front solution tank cover D. Operator seat P. Hour meter E. Batteries Q. Circuit breakers F. Solution tank empty indicator B. Recovery tank full indicator C. Battery charge level indicators D. Fault indicator E. Emergency Stop Button F. Directional switch G.
Horn button H. One Step scrub button J. For best results, use the correct brush type for the cleaning application. The following are Normal water passes through a module where it is recommended brush applications. Stop machine on a level surface. Place the rear squeegee under the squeegee mount bracket and fasten with the two knobs.
Then set the preferred light. Release the propel pedal to stop the machine. Scrubbing functions stop and the automatic park brake will engage when the machine stops. The Brake pedal can be used to control the machine if quicker stopping is needed or if operating on an incline. For heavily soiled areas, use the double scrubbing method.
NOTE: It is easier to put the side squeegees back on to the machine with the scrub head Double scrubbing can be performed using the partially lowered. Adjust the machine speed, brush pressure, and To pick up water or non--flammable liquid spills, solution flow as required when scrubbing. When the batteries are fully charged, all five lights are lit. As the batteries discharge, the lights go out until only the left light is blinking.
When the left light blinks, the scrubbing functions will shut off to alert the operator of the battery condition. Refer to the table below to determine the cause for the fault or failure. Indicator s Cause s Remedy Once a circuit overload. When cleaning is finished, or when the recovery tank full indicator comes on, the recovery tank should be drained and cleaned. The solution tank then can be filled again for additional cleaning. Close the recovery tank cover.
Carefully push the recovery tank forward to close the solution tank. Remove the solution tank drain hose. While holding the hose up, remove the plug, then slowly lower the drain hose to the floor drain or sink. Cylindrical scrub head: Remove and clean the debris tray. Place the tray back in the scrub head when finished. Replace the solution tank drain hose cap and mount the drain hose back onto the mounting clip after after the tank is drained.
The lifetime of the batteries before and after charging, and after every 50 is limited to number of charges the batteries hours of operation. Lead acid batteries: Check the water level in adding distilled water.
If the water and acid are not all battery cells. If the level is low, add just thoroughly mixed, the readings may not be enough distilled water to cover the plates. Plug the battery charger into the wall outlet. The belts drive the should be inspected after the initial hours of cylindrical brushes. Make sure the scrub head is in the raised position. The Safe Scrubbing Alternativer. Previous Page. Next Page. Featuring foam scrubbing technology and hygenic tanks 48 pages.
Page 2 2. B Identify the machine serial number from the data label. Parts and supplies may be ordered online, by phone, by fax or by mail. Brush Pressure Meter Control Console Height Adjustment Lever Hour Meter 6.
Keep Hands Away. Raise the scrub head and pull the machine away. Observe the brush pattern on floor. If the brush pattern is uneven or tapered, adjustment is FIG. Reconnect drive motor wire. Recheck brush pattern. Inspect the cylindrical brushes for wear.
Rotate brushes from front--to--rear every 50 hours Figure Check the condition of the squeegee blade wiping FIG. Make sure the solution tank is empty before removing filter. Clean the parking brake clamp with a cleaning solvent.
0コメント